(DOCK INSTALLATION ONLY) TOOLS NEEDED
If your spa does not already come with a Dock, you will need:
- Drill
- Stainless Steel 15/64” Bit
- Phillips Screw Driver
- Masking Tape
- Washable Marker
- Rubbing Alcohol
TO INSTALL THE DOCK:
- Determine an area on the spa where the Dock will be installed undisturbed, and place a 3” strip of masking tape on the area, approximately 2” parallel above the water line. This will create a nonslip surface as you drill.
- Use the Dock to mark the tape where the drill holes should be.
- Using a 15/64” stainless steel bit, slowly drill a hole through the tape marks.
- Remove the tape and clean the mounting surface with rubbing alcohol.
- Peel off the Dock sticker protection, align the holes and press onto the spa wall.
- Insert the provided screws. IMPORTANT: Do not over tighten.